Rotomolded Volute Housing


Centrifugal fan volute with brass threaded inserts molded into the front bolt circle and a tangential side discharge; a mounting component rather than a carried part, tooled to your motor plate drawing

Category:

Cleaning equipment series

Description

Product Overview

This volute housing is the part everything else bolts to — motor plate, inlet ring and the machine frame around it. It is rotomolded in black with brass threaded inserts molded into the bolt circle on its front face, so the fastening points are metal rather than tapped plastic.

The discharge leaves tangentially at the side and rear, and there is no handle: this is a mounting component, not a part that gets carried.

Brass Inserts Molded into the Wall

Each insert is placed in the tool before the cycle runs, so the polyethylene flows around its knurl and locks it in place as the wall forms. The bolt then threads into brass. On a machine opened for impeller or motor service, that is the whole point: cut threads in plastic wear first, and inserts do not.

Because the insert is captured during molding rather than pressed in afterwards, it stays square to the bolt circle and does not turn when a screw is backed out.

Tangential Discharge, Continuous Ring

The volute ring wraps the impeller and turns its discharge into a single tangential outlet at the side. The wall is continuous from cut-off to throat, so the air sees the passage the impeller was drawn for.

Where the machine is mounted on a flat deck instead of bolted at the front face, the centrifugal blower housing with a molded base plate is the other option in this family.

Product Specifications

SpecValue
ProductVolute Housing
MaterialLLDPE, per machine drawing
ProcessRotational molding with inserts placed in the tool
FasteningBrass threaded inserts molded into the front bolt circle
Air pathVolute ring with tangential discharge at the side and rear
Front faceMolded flat, with the insert bolt circle
ColorPigmented in the resin, per order
DutyCentrifugal fans and blowers in cleaning and drying equipment

Why Rotational Molding

Rotomolding lets the inserts go into the tool before the wall exists, so they end up captured in solid plastic instead of driven into a finished hole. The tool is a casting, so insert count, thread size and bolt-circle diameter follow your motor plate drawing and can be changed between runs.

What to Send Us

Send the motor plate and impeller layout, the thread size and the bolt-circle diameter, and how often the joint is opened in service. If this replaces an existing volute, send the old part or its drawing. See also our centrifugal blower housing and the fan scroll housing with a slotted side bracket.

FAQ

1. Can we specify the insert thread and count?

Yes. Thread size, insert count and bolt-circle diameter are set to your motor plate drawing.

2. Are the inserts molded in or fitted afterwards?

Molded in. They are loaded into the tool before the cycle, and the resin flows around the knurl as the wall forms.

3. Can the discharge angle be changed?

Yes. The tangential outlet position is tooled to your machine layout.

Product inquiry

Note: Please leave your phone number or E-mail and our professionals will contact you as soon as possible!