Blower Scroll with Bracket


Molded scroll with a slotted side bracket for hanging or base mounting, a round inlet with a molded inner ring, a rectangular discharge and a flat label face; tooled to your motor drawing.

Category:

Cleaning equipment series

Description

Product Overview

A scroll inside a cleaning machine has to fit wherever the frame leaves room. This black housing is rotomolded with a slotted bracket on its side, so the same part can hang from a panel or sit down on a deck.

The round inlet carries a molded inner ring that locates the impeller mouth, the discharge is rectangular, and one side of the shell is molded flat as a label face.

Slotted Bracket, Two Mounting Modes

The bracket is a molded tongue with a slot in it rather than a plain hole. That lets the housing be hung on a stud and then slid to its final position, or bolted down without anyone holding the part at exactly one height while the screw goes in — useful on a machine where the scroll sits behind other components.

Slot length, width and position on the shell are tooled to your frame, as is the number of brackets.

Located Inlet, Flat Label Face

The inner ring at the inlet is molded with the scroll, so the impeller mouth is located by the housing itself and not by the motor plate pulling it into place. Keeping that concentric is what stops the wheel from rubbing.

The flat side face is molded smooth for a decal or rating plate. On a curved shell a label lifts at its edges; here it has a surface to sit on.

Product Specifications

SpecValue
ProductFan Scroll Housing
MaterialLLDPE, per machine drawing
ProcessRotational molding, one-piece seamless shell
Air pathMolded scroll with round inlet and rectangular discharge
InletRound inlet with molded inner ring
MountingSide bracket with molded slot, hang or base mount
Label faceFlat molded area on the side of the shell
DutyBlower scrolls for cleaning and floor drying machines

Why Rotational Molding

Scroll, inlet ring, bracket and label face come out of a single cycle with no bracket to weld and no plate to bond on. The tool is a casting, so the slot geometry, the discharge position and the flat face follow your machine drawing and can be revised between production runs.

What to Send Us

Send the impeller layout, the mounting face or stud position the bracket has to meet, and the discharge direction. If this replaces an existing scroll, send the old part or its drawing. See also our axial fan housing for through-flow layouts and the volute housing with brass threaded inserts.

FAQ

1. Can the bracket be on the other side of the shell?

Yes. Bracket position and count are set in the tool to suit your frame.

2. Can the slot be replaced with a round hole?

Yes. The bracket can be tooled with a plain hole, a slot or both.

3. Is the label face large enough for a rating plate?

It is molded to the size you specify — send the plate dimensions with the drawing.

Product inquiry

Note: Please leave your phone number or E-mail and our professionals will contact you as soon as possible!