Rotomolded Axial Fan Housing


Rotomolded axial fan housing: square frame with a large circular through-opening, molded top handle, corner holes and bottom tabs. OEM per drawing.

Category:

Cleaning equipment series

Description

Product Overview

An axial fan does not need a scroll — it needs a frame that holds the fan square to the opening and keeps hands and cables clear of the blades. This housing is rotomolded as a blue square frame with a large circular opening through the whole front face, so the fan sits inside the mouth and the frame mounts to the machine.

A handle is molded across the top, corner holes take the mounting bolts, tabs on the bottom engage the panel or base below, and flat recesses in the sides leave room for a guard, a label or cable routing.

Square Frame, Round Mouth, One Cycle

A square outer frame and a true circular bore in one part is the reason to rotomold this. The bore is molded concentric with the frame, so the fan drops in without shimming, and the wall behind it is continuous — no welded ring to line up.

The through-opening also means the same housing works whichever side of a panel the fan blows from. Air enters one face and leaves the other, with the frame doing the locating.

Mounting and Details Molded In

Corner holes and bottom tabs are formed with the frame, so the part cannot rack out of square when bolted down and the tabs hold it in place before the screws go in. The top handle is part of the same wall.

The side recesses are molded flat on purpose: a guard, decal or cable clip sits flush instead of standing off a curved surface.

Product Specifications

SpecValue
ProductAxial Fan Housing
MaterialLLDPE, per machine drawing
ProcessRotational molding, one-piece frame
GeometrySquare frame with a large circular opening through the front face
MountingCorner mounting holes, snap tabs on the bottom
Side featuresFlat molded recesses for guard, label or cable routing
HandlingMolded carry handle on top
DutyAxial fans in cleaning, drying and ventilation equipment

Why Rotational Molding

A square frame around a round bore, with tabs, holes, recesses and a handle, is one rotomolding cycle. The tool is a casting, so bore diameter, corner hole pattern and tab position follow your fan and panel drawing and can be revised between runs.

What to Send Us

Send the fan diameter and its mounting pattern, the panel opening and the tab or hole positions you need. If this replaces an existing frame, send the old part or its drawing. See also our fan scroll housing for centrifugal layouts and the carpet dryer housing from the same blower family.

FAQ

1. Can the bore be tooled to our fan diameter?

Yes. Bore diameter and depth are mold geometry and follow your fan specification.

2. Can the tabs and corner holes be repositioned?

Yes. Send the panel layout and we will set them in the tool.

3. Is the housing supplied with a guard?

The frame is supplied as molded; guard mounting can be tooled into the recesses if you supply the guard.

Product inquiry

Note: Please leave your phone number or E-mail and our professionals will contact you as soon as possible!