Rotomolded Floor Dryer Housing


Large rotomolded floor dryer housing with a deep arched handle, round inlet with flat sealing flange, front discharge and rear port. OEM per drawing.

Category:

Cleaning equipment series

Description

Product Overview

Full-size floor dryers are carried all day and set down hard. This housing is rotomolded in one piece with a deep arched handle across the top — part of the wall, with molded grip points, so the machine can be lifted and tilted without a separate bar bolted through the shell.

The round inlet is surrounded by a flat flange ring with screw bosses spaced around it, giving a sealing face for the motor plate or inlet grille. A rectangular discharge opens low at the front, and a small round port at the back is molded in for cable or sensor pass-through.

Handle and Scroll in One Wall

Because the handle is molded with the shell, the lifting load runs into the wall instead of into two screws through it. The grip points are molded recesses, so there is nothing to assemble and nothing to come loose in service.

The depth of the arch also keeps a hand clear of the inlet and the controls mounted behind it.

Flat Flange for a Sealed Inlet

The flange ring around the inlet is molded flat and its bosses are spaced around the circumference, so a gasket or grille clamps evenly instead of pulling the ring out of round. Sealing the inlet is what keeps air from bypassing the impeller around the outside of the wheel.

The small rear port is molded with the shell as well. It gives the wiring or a sensor a defined route out of the air path, with no hole to drill during assembly.

Product Specifications

SpecValue
ProductFloor Dryer Housing
MaterialLLDPE, per machine drawing
ProcessRotational molding, one-piece seamless shell
Air pathMolded scroll, round inlet, rectangular front discharge
Inlet interfaceFlat flange ring with peripheral screw bosses
Service portSmall round molded port at the back for cable or sensor
HandlingDeep arched handle with molded grip points
DutyFull-size floor dryers and air movers, OEM machines

Why Rotational Molding

A shell this size, with a deep handle, a sealing flange and a service port, is one rotomolding cycle. The tool is a casting, so the flange face, the boss layout and the handle arch follow your dryer drawing and can be adjusted between runs.

What to Send Us

Send the impeller and motor plate layout, the inlet flange detail and where the cable or sensor has to leave the shell. If this replaces an existing housing, send the old part or its drawing. See also our air mover housing for compact machines and the carpet dryer housing with a top discharge duct.

FAQ

1. Can the inlet flange take a gasket?

Yes. The ring is molded flat and bosses are spaced so a gasket clamps evenly.

2. Can the rear port be moved or removed?

Yes. Its position and size are tooled to your wiring layout, and it can be omitted.

3. Can the handle depth change?

Yes. Handle depth and grip positions follow your lifting requirements.

Product inquiry

Note: Please leave your phone number or E-mail and our professionals will contact you as soon as possible!