Structural Rotomolded Cleaning Machine Body


Load-bearing structure with a large open cavity at the top, a stepped base deck carrying molded screw bosses and an L-shaped side profile; tooled to your machine drawing.Load-bearing structure with a large open cavity at the top, a stepped base deck carrying molded screw bosses and an L-shaped side profile; tooled to your machine drawing.

Category:

Cleaning equipment series

Description

Product Overview

This grey part is not a cover that hides a frame — it is the frame. A large open cavity occupies the upper volume and serves as the machine's holding chamber for water or collected debris. Below it, a stepped base deck runs out into the machine footprint, carrying molded screw bosses that take components directly.

A skirt drops down the sides, and the whole part steps back in an L-shaped profile so the rear face can meet the machine upright. One molding replaces several assembled pieces.

The Deck Carries the Load

The stepped base is what makes this a structural body rather than a shell. Its platforms sit at different heights for different components, and the screw bosses rise out of the deck as part of the same wall. Components bolt to molded material instead of to a separate bracket bolted through a thin skin.

The steps also stiffen the deck. Each change in height breaks a flat panel into two shorter spans, which is how the body holds its shape under mounted weight without extra thickness.

Open Cavity, Fewer Separate Parts

Because the cavity is molded into the top of the body, the machine does not need its own tank or catch tray dropped inside it. That removes a part, its seals and its fixings from the assembly. The skirt closes the sides down to floor level so whatever the machine picks up stays inside the profile.

Product Specifications

SpecValue
ProductCleaning Machine Body, Structural
MaterialLLDPE, per machine drawing
ProcessRotational molding, one-piece load-bearing body
StructureOpen top cavity, stepped base deck, side skirt, L-shaped rear profile
MountingMolded screw bosses on the stepped deck, layout per drawing
FinishPigment in the resin, molded-in texture
DutyCleaning machines where the housing serves as chassis

Why Rotational Molding

Cavity, stepped deck, bosses and skirt come out of one cycle as the same continuous wall, so there is no joint between the load path and the container. Rotomolding also gives even thickness through the step transitions and around each boss — the places a fabricated assembly reinforces with extra plates and fasteners. Tooling is cast, so step heights and boss positions follow your component layout.

What to Send Us

Send the component list with weights and fixing centres, plus the volume the top cavity has to hold. If this replaces an assembled frame and tray, send that. See also the rotomolded hinged housing and the cleaning equipment housing.

FAQ

1. Can the base steps be rearranged for our components?

Yes — step heights and boss positions are mold geometry set from your layout drawing.

2. Does the open cavity need a separate liner?

No extra part is required. The cavity wall is continuous with the body, so it cleans down without a seam to work around.

3. Can the rear of the L take an upright or handle?

Yes. Send the upright section and fixing pattern and the mating face is molded to it.

Product inquiry

Note: Please leave your phone number or E-mail and our professionals will contact you as soon as possible!