Rotomolded Cleaning Equipment Housing with Service Window


Green rotomolded cleaning equipment housing with a large service window opening through to the internal service position, vertical ventilation grille ribs molded into the face, and a handle recess. Window and grille come out of the same molding cycle.

Category:

Cleaning equipment series

Description

Product Overview

This is the top hood of a walk-behind floor scrubber, and the feature that shapes the page is the rectangular opening in the top face. A raised flange with bolt holes molded along its edge frames it, so the tank bay and controls underneath are reached without pulling the hood off. The opening edge comes out of the mold finished - no hand trimming, no raw cut to seal, no drilling to locate.

Ribs run across the wide top face where the shell spans unsupported, a recessed grip at the front helps lifting during tank service, and the skirt steps down to a darker section in the splash zone. The two-color break sits on a molded step, so the line between green and dark gray is geometry, not a trim strip. It is produced through our custom rotomolded plastic parts service on the same production basis as our cleaning machine housing line.

Product Specifications

ProductFloor scrubber hood, rotomolded
MaterialImpact-grade PE, UV-stabilized, detergent-resistant
ProcessRotational molding, one-piece hood shell
Service windowFlanged opening with molded bolt-hole flange
Color breakTwo-tone on a molded step line
StiffeningRibbed flanks and top-face rib pattern
InsertsFastener bosses positioned per drawing
ServiceOEM production to customer design

Why the Window Is Molded, Not Cut

An opening can be added to any shell with a router. What a mold-formed window adds is the frame: the flange rises with a flat landing for the gasket and a clean line of bolt holes, all in the same cycle as the shell. That landing is what makes the window watertight, because the seal sits on a molded plane instead of a cut edge that varies with every router pass. It also locks the window position at drawing stage, so the tank hatch and controls underneath are designed around it once and repeat across the run.

Where This Hood Earns Its Keep

  • Tank strips and daily checks happen through the window, so hood removal becomes a monthly job.
  • The ribbed top face carries hose drag, mop weight and stacked parts without oil-canning.
  • The molded color step keeps the machine two-tone after years of scuffing, because the colors are in the material.
  • Detergent splash wipes off PE without lifting paint, so the hood stays presentable.

Working With Us

Send the hood outline, window position and fastener layout in any readable form - sketch, CAD or marked-up photo. We come back with a wall plan that puts thickness where the flange and ribs need it, and a quote split into tooling and unit cost. First articles are molded in production material and go to your machine fitted. Most hood projects settle in one round of drawing comments, and the window is the feature worth arguing about on paper: once the tool is cut, moving it means a tool edit and a re-run of the sealing test.

FAQ

Can the window take a clear cover?
Yes. The flange accepts a polycarbonate panel with a gasket, and the bolt pattern follows your drawing to match your hinge and latch hardware.

Is the two-color finish a paint process?
No. Both sections are pigmented PE molded in one shot, so the color break cannot peel or chip the way paint does under squeegee scrape.

We have a hood tool - can you run it?
Yes. We run customer and third-party tools regularly, and we do not build molds ourselves, so bringing an existing tool here is a normal path.

Product inquiry

Note: Please leave your phone number or E-mail and our professionals will contact you as soon as possible!