Foshan Nanhai Jinsumei Environmental Protection Plastic Product Co., Ltd.
Products
Grey S-Curve Solar Pool Shower Column
Cleaning equipment series
Description
Product Overview
Where a straight column leans, this one flows. The body runs as a continuous S from the foot to the head, and the visible consequence is a shape that reads as one line instead of a pillar with a joint in it. The practical consequence sits at the bottom: the shell flares into a bell foot, so the widest point of the column is also its lowest, and the water held there drops the center of gravity well below a straight tube of the same height. On a pool surround that gets hosed down and leaned against, the broad foot does more than a heavier fixing would.
Rotomolding is what allows the shape to be a single skin. The S section, the flare at the foot and the head arm come out of one mold in one cycle, the wall thickness following the sweep rather than stepping at a joint. The section is a smooth hydrodynamic oval rather than a tube, spreading the sun across a wider face and helping the column heat its water. Foot width, height, inlet thread and head position are set per program, and the shell is produced through our custom rotomolded plastic parts service alongside the rest of our rotomolded marine products.
Product Specifications
| Product | Grey S-Curve Solar Pool Shower Column |
| Shell | LLDPE or HDPE, UV-stabilized |
| Form | Continuous S-curve, foot to head |
| Section | Smooth elliptical cross-section |
| Base | Flared bell foot, widening to the floor |
| Outlet | Shower head at the top of the curve |
| Water feed | Low-level inlet, hose thread per market |
| Color | Molded into the resin, grey as standard |
| Dimensions | Per drawing / per program |
What the S Shape Changes
- The bell foot is the ballast. Water sits lowest where the shell is widest, so the column is heaviest at the floor and lightest at the top — the opposite of a straight tube, which is neutral all the way up.
- An elliptical section rotates differently in the mold. The tool and cycle are set up so powder reaches the narrow edges of the oval, and that review happens before the drawing is frozen.
- The sweep needs clearance on both faces. An S occupies more plan area than a pillar of the same height, so check what the curve swings past.
- Grey hides water spotting better than dark blue or black. Because the pigment is in the resin, the choice is settled once at molding and stays for the life of the shell.
FAQ
Why the flared base instead of a flat flange?
The flare widens the footprint so the column cannot be tipped by a lean, and it holds the low water that acts as ballast. A flat-flanged pillar relies entirely on its fixings.
Is a full S-curve harder to mold than a straight column?
It needs more care at drawing stage, because the powder has to reach round the sweep and into the narrow edges of the oval section. Once the tool is proven, the parts repeat the same as any other molding.
Can we add a foot-rinse outlet near the base?
Yes. A low take-off suits the shape well because the base is already the widest part of the shell. It is a tooling feature, so it goes on the drawing rather than being fitted later.
Does the bell foot still bolt down?
Yes. Fixing points are molded into the foot, and the hole positions are set to your drawing in the same way as the straight models.
Keywords:
Product inquiry
Note: Please leave your phone number or E-mail and our professionals will contact you as soon as possible!