Sloped-Top Equipment Water Tank with Overflow Spout


White rotomolded equipment water tank with a sloped top corner, an overflow spout at the shoulder, a molded grip recess and stiffening bands. One-piece seamless body for machine bays, geometry per drawing.

Category:

Water Tanks Series

Description

Product Overview

Machine bays are not drawn around tanks; tanks are drawn around machine bays. This equipment water tank is rotomolded as a white vertical body with one top corner sloped away — the clearance the machine's hood line or frame brace needed — and the volume kept everywhere else.

The shoulder carries a small spout for the overflow or vent line, placed where it drains clear of the fittings below. On the upper face, a molded grip recess gives hands a purchase when the tank comes out for service, and two bands around the body stiffen the wall over its height. The bands, like everything else here, are wall geometry formed in the mold.

Clearance Is Capacity

The sloped corner is not lost volume — it is the reason this tank fits where a rectangular one would not, at a capacity a smaller square tank could not reach. That is the trade a rotomolded tank makes cheaply: the slope is in the mold, so the bay drawing sets the angle. Send it, and the geometry follows — the same logic as our custom vehicle tanks.

Product Specifications

SpecValue
ProductSloped-Top Equipment Water Tank
MaterialLLDPE, per machine duty
ProcessRotational molding, one-piece seamless body
ShapeVertical body with one sloped top corner
SpoutShoulder spout for overflow or vent
GripMolded recess on the upper face
StiffeningTwo bands around the body

Why Rotational Molding

The spout, the recess, the bands and the sloped corner are all formed with the body in one seamless cycle — nothing added, nothing welded, nothing to work loose in a vibrating bay. And because the tooling is a casting, the slope angle and spout position can change between sample and production as the machine design settles.

FAQ

1. Can the slope match our hood line?

Yes — send the bay or hood drawing and the corner angle follows it.

2. Can the spout take a hose?

Yes, its length and finish are molded to your overflow or vent line. See also the angular equipment tank and the machine tank with brass fittings.

Product inquiry

Note: Please leave your phone number or E-mail and our professionals will contact you as soon as possible!