Ride-On Scrubber Recovery Tank


Grey rotomolded recovery tank for ride-on floor scrubbers with molded internal partitions separating clean and dirty water, a center sump with fitting seat, corner posts for the chassis, side handle recesses and an arched base access. One-piece seamless body.

Category:

Water Tanks Series

Description

Product Overview

The tank on a ride-on scrubber is the machine: it sets the water range, the weight distribution and the service schedule. This ride-on scrubber tank is rotomolded as one grey body that carries the machine's whole water system — clean solution and dirty recovery — separated by partitions molded into the same wall, with a center sump seated for the pump fitting.

The open top shows the internal architecture: channels and dividing walls guiding water to the sump, not fighting it. Corner posts rise to meet the machine's chassis and carry the cover; deep handle recesses in the sides give the tank a grip for installation and hoisting; and the arched opening at the base clears the frame structure and the squeegee mechanism beneath.

Molded, Not Assembled

Every internal feature — partitions, sump, channels, posts, recesses, arch — comes out of the mold as one seamless piece of polyethylene. There is no welded divider for dirty water to weep through, no bolted sump plate to work loose. The tank cleans out completely at service and goes back to work; that is the standard a ride-on machine sets for its largest component.

Product Specifications

SpecValue
ProductRide-On Scrubber Recovery Tank
MaterialLLDPE, per cleaning-machine duty
ProcessRotational molding, one-piece seamless body
Internal structureMolded partitions, channels and center sump
InterfaceCorner posts, side handle recesses, arched base access
FittingsSump seat and bosses per machine drawing
DutyRide-on floor scrubbers, OEM cleaning machines

Why Rotational Molding

No other process makes this shape in one piece. Fabrication would weld a dozen seams into the wet zone; blow molding cannot hold the wall detail. Rotomolding forms the whole architecture in a single cycle, and because tooling is a casting, partition positions and sump depth follow your machine drawing and can move as the design matures.

What to Send Us

Send the chassis interface drawing, the water-balance split between solution and recovery, and the pump and fitting layout. If the tank replaces an existing one, send that. See also the yellow solution tank of the same family and the cleaning machine tank with pump sump.

FAQ

1. Can the partitions match our water balance?

Yes — partition and sump positions are mold geometry set by your machine's clean/dirty split.

 

Product inquiry

Note: Please leave your phone number or E-mail and our professionals will contact you as soon as possible!