Black Ribbed Rotomolded Machinery Fuel Tank


Black rotomolded machinery fuel tank with deep vertical ribs, a top filler cap and an integrated side mounting flange with bolt holes. One-piece body, fittings per drawing.

Category:

Fuel Tanks Series

Description

Product Overview

Machine bays punish flat walls. Vibration off the engine finds the widest panel and works it until it drums, cracks or shakes its own fixings loose. The ribbed body in this tank is the answer formed at the molding stage.

This tank is rotomolded in black polyethylene as a one-piece body with deep vertical ribs running across the faces, a horizontal groove around the waist that divides the panels twice, and a top filler cap on a reinforced neck. Mounting is built in: the side face carries an integrated flange bracket with molded bolt holes, so the tank bolts directly to the machine frame without a separate bracket set.

For a grey square body with a wide cap, compare the square machinery tank; for a body that mounts low across a chassis, the low-profile flat tank.

How the Ribs Work

The vertical ribs and the waist groove break each wide face into short spans. A short span cannot drum under vibration or bulge under a full tank the way a wide flat panel does, so the wall can stay at standard thickness while the body behaves like a much heavier tank.

Because the ribs are molded, they are part of the wall — there is nothing bonded on to shake loose, and the radii at each rib root spread the stress instead of concentrating it the way a welded stiffener does.

The Side Flange Bracket

The mounting flange is molded as part of the body, with a flat bearing face and bolt holes set from your frame drawing. Bolt load goes into the thickened flange material and then into the wall, so the tank hangs on its own structure. Further mounting points sit on the base per your layout, and outlet, vent and drain bosses are placed wherever the machine plumbing runs.

Product Specifications

SpecValue
ProductBlack Ribbed Rotomolded Machinery Fuel Tank
MaterialLLDPE or HDPE
ProcessRotational molding, one-piece body
StiffeningDeep vertical ribs plus waist groove, molded in
FillerScrew cap on a reinforced top neck
MountingIntegrated side flange bracket with molded bolt holes; base points per drawing
PortsOutlet, vent, drain and sender per drawing
ApplicationGenerator sets and industrial machinery

Why Rotational Molding

Ribs, groove, flange bracket and filler neck are all geometry, and geometry is what rotomolding does cheapest: one tool, one cycle, and the wall stays seamless through every feature. A steel tank of the same stiffness needs welded stiffeners and a bolted bracket; here both are part of the molding. The black compound is carbon-black based, which also gives the wall a level of static dissipation for diesel duty.

What to Send Us

Send the bay dimensions, the flange hole pattern, the capacity and the port list. If the tank replaces an existing steel or plastic tank, send that and the mounting pattern transfers directly.

FAQ

1. Can the flange bracket move to another face?

Yes. The bracket is molded wherever your frame needs it — side, back or both — with the hole pattern from your drawing.

2. Is the rib depth fixed?

Rib depth and spacing follow the span each face has to cover. Send the bay size and loading, and we set the rib pattern at tooling.

3. Can it carry a level sender?

Yes. The sender boss is molded to your flange pattern. Send the bolt circle.

Product inquiry

Note: Please leave your phone number or E-mail and our professionals will contact you as soon as possible!