Compact Rotomolded Fuel Tank for Generators


Natural rotomolded generator fuel tank with a tethered ribbed cap, rounded one-piece body and stepped base. Sits inside or beside generator frames. Built to drawing. OEM.

Category:

Fuel Tanks Series

Description

Product Overview

A portable generator's tank gets moved by its frame, set down on gravel, loaded into a van and refilled in the field. The tank that lives under that frame needs rounded corners, a cap that cannot be dropped in the grass, and a base that finds its own position on the frame.

This tank is rotomolded in natural polyethylene as one piece, with a rounded compact body and a stepped base that locates the tank on the frame rail before the fixings go in. The ribbed screw cap sits on a raised neck at the highest point, on a molded tether so it stays with the tank when it comes off.

The natural shell shows the fuel level through the wall — on a small generator, that replaces a gauge. Pigmented colors are available where the tank sits inside a housing.

Filling and Connections

The cap neck stands at the highest point of the molding, so the tank fills fully and the last liters are usable. The ribbed cap grips with wet or gloved hands, and the tether keeps it attached — a small detail that matters on machines refilled dozens of times a season.

Outlet, vent and drain ports sit on molded bosses placed from your engine layout, and the drain reaches the low point of the base so the tank empties completely when it is put away for the season. For an open-top shell in the same machine family, see the open-top machine body.

Mounting

The stepped base carries molded mounting points, positioned from your frame drawing. The tank bolts into the generator frame with inserts, so no strap kit is needed unless your design specifies one.

Product Specifications

SpecValue
ProductCompact Rotomolded Fuel Tank for Generators
MaterialLLDPE or HDPE
ProcessRotational molding, one-piece body
ShapeRounded compact body with stepped base
FillerRibbed screw cap on a raised neck, molded tether
PortsOutlet, vent and drain per drawing
ColorNatural (level visible) or pigmented
ApplicationPortable generator sets and small equipment

Why Rotational Molding

Rounded shapes are where rotomolding is most itself: the powder coats the mold evenly over every curve, so the strongest geometry is also the cheapest to mold. The neck, the tether, the stepped base and the bosses form in the same cycle, and the tank stays seamless through all of it.

What to Send Us

Send the frame drawing of the generator, the capacity, the cap specification and the port list. If you are replacing an existing tank, the old part plus the port list is enough.

FAQ

1. Can the tank sit inside our existing frame?

Yes. The body is sized to the frame envelope you send, including the base step position. The fit is confirmed on paper before tooling.

2. Is the cap tether removable?

The tether is molded with the neck. Tell us at quotation if your design wants the cap free, and the tool is built without it.

3. Can the tank be made in a color to match the generator?

Yes. Color is compounded through the wall and matched to your sample.

Product inquiry

Note: Please leave your phone number or E-mail and our professionals will contact you as soon as possible!