Rotomolded Carpet Extractor Housing


Tank body under a domed top, with a round opening and lid seat, a curved arm handle molded into the side and angled wall ribs; built to your extraction machine drawing.

Category:

Cleaning equipment series

Description

Product Overview

This carpet extractor housing is the outer body of a carpet cleaning machine: a red tank section below and a grey dome on top, molded as separate parts and assembled at the color break. The body itself is the machine's water chamber housing, so its walls carry the solution and recovery load the extractor works with.

The dome carries a round opening with a formed seat for the lid, giving fill and clean-out access from above. On the side, a curved arm handle is molded as part of the shell rather than bolted on, and angled ribs run down the body walls to stiffen them against the load inside.

Handle Molded With the Shell

A fitted handle is a bracket, four fasteners and a leak path through the wall. Here the arm comes out of the mold with the housing, so load goes into the shell itself and there is no hardware to work loose. The grip form follows the shell's curve and takes the pull of a loaded machine.

Handle position, rib layout and the lid seat diameter are all mold geometry set by the drawing. They can be tuned as the machine's capacity and lifting points are settled.

Product Specifications

SpecValue
ProductCarpet Extractor Housing, tank body with dome top
MaterialLLDPE, per machine drawing
ProcessRotational molding, handle and ribs formed in cycle
ColorRed body, grey dome; pigment in resin
Top interfaceRound opening with formed lid seat
HandlingCurved arm handle molded integral with the shell
StructureAngled ribs on the body walls; dome top closing the chamber
DutyCarpet extractors and carpet cleaning machines, OEM builds

Why Rotational Molding

The dome, the round lid seat, the curved arm and the angled ribs all come out of a single cycle, with no seam between the handle and the wall it pulls against. A fabricated body would join those pieces with fasteners in the wet zone. Tooling is a casting rather than a machined block, so rib layout and handle position follow your drawing and can still move while the design settles.

What to Send Us

Send the housing drawing with the lid opening, the handle position and the rib layout marked, plus the chamber volumes the body has to enclose. If this replaces an existing shell, send that part. Related: the compact scrubber body and our floor scrubber housing.

FAQ

1. Can the handle be moved to another side?

Yes. It is mold geometry, so position and grip form follow the lifting points on your machine.

2. Does the top opening fit our existing lid?

Send the lid drawing or a sample and we form the opening and seat to match it.

3. Can the body and dome be one color?

Yes — pigment is mixed into the resin, so the color split is set by your drawing.

Product inquiry

Note: Please leave your phone number or E-mail and our professionals will contact you as soon as possible!